Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
network problem when activating eth0
#1

Problem Connection shareing. Everything was running fine VIA 2 NIC's and a crossover cable. Then last night i llost all net.

eth0 = internal connection

eth1 = exterior connection

I cannot get net when i activate eth0 for connection shareing. it kicks me off the net. It was working fine untill last night it hjust stopped and i didnt change any settings

Both nic cards lite up so its not a cable or hardware problem. I just dont understand this.

Any suggestions?

Reply
#2
check all your IP settings and make sure two computers aren't using the same IP address
Reply
#3

While it may not seem like a card/cable problem, always check that first, by swapping the cards and cables. Also, check with your ISP to see if there was a service outage, or try re-newing your WAN IP.

 

-beej

Reply
#4
Thanks alot guys i tried all of that allready but now it seems that my OS has died. So it most likely was just a software problem. I dont know why it just died but it was booting slow then i couldnt get any gui's to run. Now when i boot it just says system boot failure please insert boot disk. So maybe the drive failed.
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)